INSTRUCTION MANUAL FOR ROOF SPOILER

STEP 1: BEFOR PAINTING, PROTECT THE BONDING SURFACES

WITH TAPE. ROUGHEN THE SURFACES OF THE ADD-ON

SPOILER WITH SANDPAPER. REMOVE ALL TRACES

OF PAINT.

STEP 2: THE BONDING SURFACES ON THE GLASS OF THE

VEHICLE AND ADD-ON SPOILER MUST BE

ABSOULUTELY DRY, CLEAN AND FREE OF WAX AND

GREASE. IMMEDIATELY BEFORE APPLYING THE

SILICON, CLEAN THE BONDING SURFACES WITH A

CLEANER THAT CONTAINS ALCOHOL.

STEP 3: AFTER CLEANING THE GLASS AND THE SPOILER,

APPLY THE PRIMER CAREFULLY TO THE BONDING

SURFACES OF THE SPOILER AND THE GLASS. ALLOW

THE PRIMER TO DRY FOR AT LEAST 10 MINUTES.

STEP 4: APPLY THE SILICON TO THE BONDING SURFACE OF

SPOILER AND USING THE SPATULA TRY TO EVEN OUT

THE AMOUNT OF SILICON USED ON THE SPOILER.

(NOTE: PUTTING TO MUCH SILOCON WOULD CUASE THE

SPOILER TO NOT SIT FLUSH ON THE GLASS).

NOTE DO NOT COVER THE HOLES UNDER THE SPOILER WITH THE SILICON

STEP 5: PLACE THE SPOILER IN THE CORRECT POSITION AND

PRESS FIRMLY. (RECOMENED TO HAVE A PARTNER AT

THIS TIME). AFTER POSITIONING THE SPOILER, USE A

3M MASKING TAPE OR SIMILAR MATERIAL TO HOLD

THE SPOILER ON THE CAR FOR ATLEAST 24 HOURS BEFORE TAKING THE TAPES OUT.